Need to pay attention to the selection of LED display

1. The shooting distance should be appropriate

As mentioned in the previous discussion about point spacing and fill factor, LED display screens with different dot pitches and different fill factors have different shooting distances. For example, an LED display with a dot pitch of 4.25 mm and a fill factor of 60% is suitable. The distance between the person being photographed and the screen is 4-10 meters, so that a good background image can be obtained when shooting a character. If the character is too close to the screen, the background will appear grainy when shooting close-ups, and it will also be prone to texture interference.


2. The spacing should be as small as possible

The dot pitch is the distance between the center points of adjacent pixels of the LED electronic display. The smaller the dot pitch, the more pixels per unit area, the higher the resolution, the closer the shooting distance can be, and of course the more expensive it is. At present, the dot spacing of LED electronic display screens used in domestic TV studios is mostly 6-8 mm. It is necessary to carefully study the relationship between the resolution of the signal source and the dot pitch, and strive to achieve consistent resolution and achieve point-to-point display. Achieve the best results.


3. The color temperature should be adjusted well.

When the studio uses the LED electronic display as the background, its color temperature should be consistent with the color temperature of the studio, in order to get accurate color reproduction during shooting. The lighting of the studio is sometimes based on the demand of the program, sometimes using 3200K low color temperature lamps, sometimes using 5600K high color temperature lamps, and the LED display screen needs to be adjusted to the corresponding color temperature to obtain satisfactory shooting results.


4. Guarantee to have a good environment

The life and stability of LED electronic displays are closely related to the operating temperature. If the actual working temperature exceeds the scope of use specified by the product, not only will its life be shortened, but the product itself will be severely damaged. In addition, the threat of dust cannot be ignored. Too much dust will cause the thermal stability of the LED electronic display to drop or even cause leakage. In severe cases, it will cause burns; the dust will absorb moisture, which will corrode the electronic circuit, causing some short-circuit problems that are difficult to check, so pay attention to keep the studio. clean.


LED electronic display has no seams, which can make the picture more perfect; lower power consumption, lower heat, energy saving and environmental protection; it has good consistency, can ensure the display of the screen without difference; the cabinet scale is small, easy to form the screen Smooth modeling; color gamut coverage is higher than other display products; has the advantage of better weak reflective characteristics, and has high operational reliability and low operating and maintenance costs in the later stage.